Mallinckrodt NPB-190 Návod k obsluze stáhnout pdf (Strana 102)

Data Port Protocol

Table 11: Status Codes

Code Meaning

Alarm Off

Alarm Silence

Low Battery

Loss of Pulse w/ Motion

Loss of Pulse

Patient MOtion

Pulse Rate High Limit Alarm

Pulse Rate Low Limit Alarm

Pulse Search

Sat High Limit Alarm

Sat Low Limit Alarm

Sensor Disconnect

Note: A sensor disconnect will also cause three dashes (- - -) to

be displayed in the patient data section of the display or

printout.

TREND DATA PRINTOUT (ASCII MODE)

The format of data displayed when a trend printout (Figure 24) is

requested is similar to that of the real-time data. The only

differences are that “TREND” is displayed in the top row instead

of the “CRC: XXXX” software verification number and there is

no “Status” column.

Readings are displayed in 4-second intervals. The values on each

row are an average for the 4-second period.

At the end of the printout an “Output Complete” line indicates

that the transmission was successful. If the “Output Complete”

line is not present, a corruption of the data may have been

detected and the data should be ignored.

1 2 ... 97 98 99 100 101 102 103 104 105 106 107 108 109 110

Žádné komentáře

Mallinckrodt NPB-190 Návod k obsluze Strana 102